Mk3 Cavalier Owners Club | Vauxhall Cavalier Dot Com

sh1t, can i drill/tap it, or would I be better sourcing an ecotec block. I was told several people built there XE bits into NE blocks what do they do.

I am building up my XE parts into an NE block as the XE one is cracked. I have noticed that a sensor is in the XE block. It is in line with the middle of the two centre cylinders on the back(inlet side/starter motor side) of the engine block. There is no hole at all in 20NE block. Does anyone know w...

were you from buudy? i had my prop recond all new rubbers n bearing and VC joint brand new rubbers and bearings :) https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-ash4/375448_2249100714108_1445917278_31865903_1428544640_n.jpg https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-ash4/392152_2249101834136...

Got the GSI up on the lift and there is about an inch and a half of play in both of the rubbers. I am able to get the bearing but apparently they don't make the rubber anymore.

Does anyone have experience with these or advice as to where to go to get them.

Cheers.

17, bought a gsi 4x4 and vectra b dti at the weekend there.

Sorted lads, cheers for all the replys. I started by checking the fuse, then put it up on the lift and checked was there power going to the pump. There was power in the wires but the pump didnt seem to be geting it. So i whipped it out and cleaned the manky connections and put it staraight to a batt...

cheers

cheers, will check that

Just bought a 91 gsi 4x4 today. I'll start a progress thread when i start it.

It not getting any fuel to the cylinders, just wondering if there is any common problems before i start looking.

Cheers.