Page 1 of 1
Dani's cavy LS
Posted: Wed Aug 20, 2008 11:41 pm
by deej027
pics as promised more to follow, will be startig a WIP in the morn too.

- cavi.JPG (106.81 KiB) Viewed 591 times

- cavi rear.jpg (111.31 KiB) Viewed 591 times
Re: Dani's cavy LS
Posted: Wed Aug 20, 2008 11:48 pm
by branny361
looks decent enough . get some elbow grease on the paintwork and bring back the lovely red colour .
Re: Dani's cavy LS
Posted: Wed Aug 20, 2008 11:54 pm
by cavyboi
looks nice bud clean the body up back to the red and it will look really nice bud
have you got any plans for it bud??
Re: Dani's cavy LS
Posted: Thu Aug 21, 2008 1:01 am
by Envoy CDX
Very nice, flame red is a wonderful colour if you can stay on top of it.
Hopefully this will be a nice Standardish cavalier with plenty of subtle mods.
Re: Dani's cavy LS
Posted: Thu Aug 21, 2008 7:01 am
by wullie
it cerainly looks clean,i'm sure once it's polished it'll look spot on my n ove ws the same it would turn pink if it wasn't polished
Re: Dani's cavy LS
Posted: Thu Aug 21, 2008 9:29 am
by Gaz
all that needs is a good buff with some g3 and it will be fine, ive seen worse than that restored
Re: Dani's cavy LS
Posted: Thu Aug 21, 2008 8:19 pm
by deej027
cavyboi wrote:looks nice bud clean the body up back to the red and it will look really nice bud
have you got any plans for it bud??
not much planned for this, finish debump stripping, shave rear door handle, up power the engine a bit more and 17's on, tinted rear and front lights. tht is about it
and more pics the blue cavi is the auto version (fast as f***k)
Re: Dani's cavy LS
Posted: Thu Aug 21, 2008 11:11 pm
by cavyboi
you have two nice cavaliers bud
both of them look clean
Re: Dani's cavy LS
Posted: Sun Aug 24, 2008 8:52 pm
by deej027
Re: Dani's cavy LS
Posted: Sun Aug 24, 2008 9:27 pm
by deej027
Re: Dani's cavy LS
Posted: Mon Aug 25, 2008 12:29 am
by cavyboi
looking good bud
are you cleaning the rocker cover on them?? or the hole engine??
Re: Dani's cavy LS
Posted: Tue Aug 26, 2008 9:10 pm
by v6sri
did you mean bolt covers for the alloys,just use wd40 and some long nose pliers