Page 1 of 1
rev limiter....20xe
Posted: Sat Sep 07, 2013 9:09 pm
by gsi pie
right here's a strange one for you all
driving my white cav tonight , was giving it some love (revving lol ) and I seem to have lost my limiter now
???
I did have one last night tho
it revs straight thro 8 like its on carbs??
it runs a groupe N ecu but that's been fitted since ive had it
how are the limiters controlled on these? ECU or dizzy?
any help would be great as don't fancy my conrods goin east
Re: rev limiter....20xe
Posted: Sat Sep 07, 2013 9:29 pm
by Gaz
ecu, mine has eds chips and it has the 8k limit.
Re: rev limiter....20xe
Posted: Sat Sep 07, 2013 9:32 pm
by gsi pie
mined use ti limit at 7.8k iirc
proper group N ecu with paper work to
so could be any ecu error /fault ya gaz?
I didn't know EDS done stuff for the XE's only LET's I thought
Re: rev limiter....20xe
Posted: Sat Sep 07, 2013 10:12 pm
by Gaz
Cant see it being anything else. planetc will probably correct me
Yea they dont do a lot tbh, i did see a small improvement but id have been pissed if it had been the £300 eds wanted
http://www.eds-motorsport.de/shop/de/Op ... steigerung
Re: rev limiter....20xe
Posted: Sat Sep 07, 2013 11:32 pm
by planetc
I can't really see it being much else either, if the limit is set in the ecu then the only way it could fail is if the ecu doesn't know the engine speed, which would lead to other problems. Rather odd really?
Re: rev limiter....20xe
Posted: Sat Sep 07, 2013 11:33 pm
by planetc
Maybe your rev counter needle has slipped?
Re: rev limiter....20xe
Posted: Sun Sep 08, 2013 12:03 am
by gsi pie
rev counter is fine as it idles fine
there is just no limiter lol
hold you foot flat and it just revs and don't stop the sound is really nasty lol
Re: rev limiter....20xe
Posted: Sun Sep 08, 2013 12:09 am
by gsi pie
just went out and wipped the ecu out
and mr chip want to leave its holder ffs
Re: rev limiter....20xe
Posted: Sun Sep 08, 2013 10:34 am
by gsi pie
can I just push the chip back in??
I don't want to fuk anything up?
thanks
Re: rev limiter....20xe
Posted: Sun Sep 08, 2013 10:36 am
by Gaz
yea but might be worth pulling it fully out you dont want it going in pissed.
Re: rev limiter....20xe
Posted: Sun Sep 08, 2013 11:16 am
by gsi pie
ok
is it just the 6 screws holding it together gaz?
last thing I want it to bugger the board up
thanks
Re: rev limiter....20xe
Posted: Sun Sep 08, 2013 4:02 pm
by Gaz
Its the plastic pin in the middle needs the centre pulling out and unclipping the pegs on the edges