Mk3 Cavalier Owners Club | Vauxhall Cavalier Dot Com

Just fitted f 28 into cav have set linkage up but it won't go into reverse helpppp..........

F28's can be a pain to setup right especially if your linkage is worn which it probably is. Make sure you use the tightest drill bits you can in the holes and if that doesn't work then you may just have to get someone to hold it abit further over whilst you tighten it.

aint as hard as every make out tbh

lift the gear gaitor up and you see 2 holes one in the stick n on by the lift up reverse bit

line these up n drop a allen or a drill bit so they are held in place then set it on the gear box

gsi pie wrote:aint as hard as every make out tbh

lift the gear gaitor up and you see 2 holes one in the stick n on by the lift up reverse bit

line these up n drop a allen or a drill bit so they are held in place then set it on the gear box

Cheers that's how I did it

ok then bk to wht dan said are the bushes worn out?