SRi non ABS master cylinder

[th0m45]

Hi guys,

removed the ABS of my cavalier, new non ABS master cylinder for it.

there is obvs 4 outlets, 2 of which have (bias/load sensing valves?) on them, rears. and 2 dont, front. now,

how do i go about the diagonals?

2 rears to the rear, right to right & left to left.
but with the front, right to left & left to right?

Also, with non ABS, do the brake lines and fuel lines share an under-body clip and both go under the drivers side of the car?

help would be much appreciated :

[th0m45]

anybody?

[Cavalier-C20LET]

first

fuel pipes on the drivers side, brake pipes on the passanger, always on the cav.

second the ones with the valves on them are for the rear,

as to what side goes where i dont think it matters, can you not just open the bonnet of stewarts astra and check? thats bound to not have abs? doesnt matter if its small block youll still see the routing .

[th0m45]

cheers for reply!

aye it is fuel pipes on the drivers side, brake pipes on the passanger. but i have little clips that look like i can put both fuel & brake lines on the 1 clip. could i not? seems pointless routing the brake lines to the passanger side when they dont need to go to the ABS unit, just strait down from the master cylinder.

hmm yeah, ill have a look at his sometime. just though somebody on here would know..

[Cavalier-C20LET]

Na keep the pipes the way they should be. There on the passanger side no matter abs or not bud.