Routing of rear ABS cables
Posted: Wed Apr 20, 2016 1:39 pm
Hi
When I was fitting my ABS cables back on to the rear wheels I couldn't quite work out the right way the cables are routed. There is a rubber O grommet next to brake line on axle fitting for brake pipe, so they go through that but after that it doesn't seem like the right way to put them over the axle, next to where the brake line clamps to rear axle, then down under the spring plate, round and then up to the wheel.
Does this sound right? It's that I don't remember the cable going over the top of the axle main beam.
Cheers
Andrew
When I was fitting my ABS cables back on to the rear wheels I couldn't quite work out the right way the cables are routed. There is a rubber O grommet next to brake line on axle fitting for brake pipe, so they go through that but after that it doesn't seem like the right way to put them over the axle, next to where the brake line clamps to rear axle, then down under the spring plate, round and then up to the wheel.
Does this sound right? It's that I don't remember the cable going over the top of the axle main beam.
Cheers
Andrew