1.7 TD Isuzu engine and new MOT

Post queries regarding your Mk3 Cavalier's fuel system (including ECUs) and exhaust here
Post Reply
Bob Dodds
Posts: 13
Joined: Fri Jul 24, 2015 7:04 pm
Location: Teesside

1.7 TD Isuzu engine and new MOT

Post by Bob Dodds »

Anyone with a 1.7 TD had theirs through the new MOT. Just wondering how mine will do with emmisions rules. Bob
User avatar
Robsey
Club Admin
Posts: 10880
Joined: Fri Dec 12, 2008 1:42 pm
Location: East Manchester

Re: 1.7 TD Isuzu engine and new MOT

Post by Robsey »

It should be fine as long as it still meets the pre-existing smoke limits.

The new MOT is aimed at vehicles with diesel particulate filters from approx 2006 onward.
1 - to ensure that they have not been tampered with.
2 - to ensure that the vehicle meets the emissions and smoke requirements.

So for you - the only change is with regard to leakages of harmful fluids.
Oil, fuel, brake fluid etc; that could be harmful to the environment or wildlife.
Bob Dodds
Posts: 13
Joined: Fri Jul 24, 2015 7:04 pm
Location: Teesside

Re: 1.7 TD Isuzu engine and new MOT

Post by Bob Dodds »

Thanks for that. Its always been good so far. I'll let you know how it does end of September.
Bob Dodds
Posts: 13
Joined: Fri Jul 24, 2015 7:04 pm
Location: Teesside

Re: 1.7 TD Isuzu engine and new MOT

Post by Bob Dodds »

My old workhorse is on the road for another year, passed its MOT with a clean bill of health and good emissions. The examiner did show me a patch underneath at the rear which is rusting. Says if I clean paint and underseal he would be happy with it next year. To Robsey you were correct about the new emissions rules, do not apply to older cars.
User avatar
Robsey
Club Admin
Posts: 10880
Joined: Fri Dec 12, 2008 1:42 pm
Location: East Manchester

Re: 1.7 TD Isuzu engine and new MOT

Post by Robsey »

Excellent news Bob,

Always nice to hear that yet another of Vauxhall's finest gets to pound the roads for another year.

Thanks for letting me know that my info was okay. Always happy to help.

As for the corrosion - yes get in there early, although I would recommend -
1 - clean the area of concern.
2 - treat with a rust converter - I use Vacatan.
3 - use a good high zinc priimer
4 - paint over the primer, although if you are under-sealing, colour will not matter.
5 - under-seal. I used a truck bed liner paint, whilst others use Shultz or Waxoyl.

Sounds a bit over the top, but it is the underside that is the corrosion weak spot on most cars.
Post Reply