volt/oil gauge

[vaux24v]

just bought a cav v6 mk3 and it has the volt/oil guage in dash (standard vaux ones not aftermarket). it has abviously been added at a later date as it doesnt work and when i slid it out of dash its not plugged in and the part its sat in (under stereo) has a back to it so no wires or owt. i was wondering if the car will have the wiring in for them? if so i will cut the back of the tray out and plug them in. if not will remove them and make use of the tray lol.

[Gaz]

It wont have the wiring.

[humbucker]

it wont have the correct oil sender switch either.

[Mort]

This topic is being discussed in another thread on this forum. See link for more information...

viewtopic.php?f=17&t=2725

They are not terribly difficult to wire in as far as I can tell, I'm in the process of fitting a set myself.

[Envoy CDX]

They are not terribly difficult to wire in as far as I can tell, I'm in the process of fitting a set myself.

Correct, it's 4 wires, it's just the routing of the wires that will require some thought.

[Mort]

They are not terribly difficult to wire in as far as I can tell, I'm in the process of fitting a set myself.

Correct, it's 4 wires, it's just the routing of the wires that will require some thought.

Hmm, that's what I'm finding. Could be a topic for a How2 there, lol. I can't decide where the best place to run the wires to is, given that I am to lazy to remove the center of the dash and am planning on making the hole in the odments tray while it is in place.

[humbucker]

run the wire from the oil sender through the grommit in bulkhead behind airbag/glovebox. other wires are internal.